The installation, debugging and operation of H.F.W Tube Mill is very necessary, because we can only achieve perfection as much as possible, but perfection does not exist, and unexpected situations will inevitably occur, which requires commissioning and solving on site.

Pay attention to the following issues when installing and commissioning ERW Tube Mill on site:

The first is the frequency commissioning of the high-frequency welding machine, because in terms of the power of the high-frequency welding machine, it is often the same, but the frequency set during work is different. This must be carefully commissioning on site. If found If it is not suitable, we need to replace the relevant components, and the frequency setting that meets the needs of the customer has been reached. I encountered this at the customer's site. After all, the high-frequency welding machine part is externally equipped by us, not produced by ourselves.

In fact, it is the debugging of the running direction and the electronic control system. There are many cables for the pipe making machine If any one of the wires is connected incorrectly or reversely, the running direction may be wrong. This is to be debugged and confirmed. When debugging and checking the running direction of the metal pipe making machine you must pay attention to the position of the horizontal axis step, and keep a certain distance between the slider and the slider to avoid getting too close. In case of reversal, a step will appear. If the thread on both ends of the horizontal is reversely twisted, the horizontal shaft must be replaced.

In addition, after the tube mill is installed and electronically controlled and debugged, the mold must be installed for trial production. This can check whether the mold design is appropriate and whether the performance of pipe mill meets the design requirements. And after being qualified, it can be officially handed over to the customer.

Generally speaking, there are not many problems with industry pipe machine, but to do this work, we must ensure that no accidents occur. Even if accidents occur, they can be dealt with in time, so that customers feel that our product quality and service quality are relatively good.